Flip Top Breadboard Ends


Alright, so next up we need to square those table tops.  The circular saw was on a job site so we had to resort to the router and a straight edge.  Not my cup of tea so I asked Nathan to do it for me.  I hate routers.  One slip and *poof*, all those hours wasted.













Then we'll need some elongated mortises in the breadboard ends.  I bought the Lee Valley Premium Hollow Chisels and they

Comments

Post a Comment

Popular posts from this blog

A Dovetail A Day

Practice Practice Practice Schwarz wrote an article. I mulled it over. I waited until I had my workbench. I waited until I had my saw. I waited until I had some scrap wood. I waited until I had some free time. I even waited until I had a marking knife and a marking gauge.  It might seem like I waited too long, but I was busy.  I wanted to make sure I had enough room in my
Read more

On Instagram, too

Because it takes a bit more effort to put the YouTube videos together, I've been posting some quick snapshots or videos to Instagram.  You can find them at http://www.instagram.com/gildedrain And a reminder of the YouTube playlist: Building a Timberframe House Quick update: The timberframe raising should be completed end of day Monday. I'm 25% done with the kitchen cabinet faces. I'm
Read more

Building a Timberframe House - 1

I'm going to attempt to record videos as we progress through the build.  I'll get better at it as I go, but right now my attention is very focused on getting the foundation correct...not on flying smoothly.  Sorry for the poor piloting skills. We broke ground April 12th, and worked through the weekend to get this far.
Read more