Flip Top Table Base, ready for joinery

Here are all the parts for the table base - all marked up and ready for joinery.






Leg




Guide Rail




Cleat




Apron


I like using hand tools, but there are some steps I prefer to use power tools for.

16 mortises go a lot faster with a hollow-chisel mortiser
8 stopped grooves in the legs for the corbels are efficiently done with a straight bit and a router table
8 peg holes end up a

Comments

Post a Comment

Popular posts from this blog

A Dovetail A Day

Practice Practice Practice Schwarz wrote an article. I mulled it over. I waited until I had my workbench. I waited until I had my saw. I waited until I had some scrap wood. I waited until I had some free time. I even waited until I had a marking knife and a marking gauge.  It might seem like I waited too long, but I was busy.  I wanted to make sure I had enough room in my
Read more

On Instagram, too

Because it takes a bit more effort to put the YouTube videos together, I've been posting some quick snapshots or videos to Instagram.  You can find them at http://www.instagram.com/gildedrain And a reminder of the YouTube playlist: Building a Timberframe House Quick update: The timberframe raising should be completed end of day Monday. I'm 25% done with the kitchen cabinet faces. I'm
Read more

Building a Timberframe House - 1

I'm going to attempt to record videos as we progress through the build.  I'll get better at it as I go, but right now my attention is very focused on getting the foundation correct...not on flying smoothly.  Sorry for the poor piloting skills. We broke ground April 12th, and worked through the weekend to get this far.
Read more